In this dialog you can do several things:
set the maximum runtime your your test run
set the minimum and maximum temperature of your temperature sensor(s)
set the minimum, maximum and nominal voltage of your power supply/ies
defined TCC <> operation mode mappings
set operation mode parameters
All those settings are provided per test group.
You first need to define one or more test groups in project wizard before you can use this dialog.
Runtime
When a test station reaches the runtime you entered here it will automatically stop.
Temperature and voltage limits
A test station will stop with a system error if one of those limits are violated.
Read more about operation mode mappings
Read more about operation mode parameters
go to initial setup guide
Last updated 7 months ago
Was this helpful?
